Pmr Forx-mas!

[I <3 Paintball]

Hey guys. I just got my PMR and I LOVE it. I just wanted to know since its all factory set, all stock, if there was anything I should adjust, and how to adjust it if so. I tried to mess with the rate of fire, and ramping mode, but I cant quite figure out how to get it to do 15bps PSP, or the Millenium setting it comes with.

How do I change Rate of Fire, and what needs to be adjusted on the gun to make my experience with it, even more enjoyable.

[I <3 Paintball]

Actually. I think I figured it out. Tell me if im right tho.

I didnt know the difference between Rate of Fire, and the different modes like 15bps or 26bps. I came to the conclusion that the Rate of Fire is a limit on how many bps you can have. Say you were in a tournament that capped the bps at 15 (PSP mode), you would need to set the Rate of Fire at 15 so you couldn't shoot past that amount of bps?

And how do I set a manual ramping bps? The gun board comes with PSP (15) and Millenium (26 I think?), but is there anyway to manually set the ramping inbetween those numbers, like at 20?

Please leave your suggestions and comments, im new to the ability to ramp.

[I <3 Paintball]

Can someone please help?

[xXProtoXx]

without a virtue or a new board i dont think you can change the bps on the set ways of ramp. But yes psp is 15 and not to sure about millineum tho.

[I <3 Paintball]

Oh no. The stock board comes with PSP and Millenium ramping abilities. I was just lost on the difference between rate of fire and ramp.
(So fun shooting PSP. My loader cant keep up with Millenium)

Also. Do I really need to mess with the trigger sensitivity and dwell? or is the factory set fine?

[Metric]

Hey hey, I got a Pmr for Christmas too :), had the same problem with ramping, I fixed it, all you got to do it read through the manual carfully. It took me a few reads through to get it though, just swith the switches inside the grips to configeration mode, and do what it says to change the rate of fire, should be in the manual, hope this helps.

[I <3 Paintball]

Hey hey, I got a Pmr for Christmas too :), had the same problem with ramping, I fixed it, all you got to do it read through the manual carfully. It took me a few reads through to get it though, just swith the switches inside the grips to configeration mode, and do what it says to change the rate of fire, should be in the manual, hope this helps.
[/b]

Oh yea, it takes a few careful read throughs. (About 10 for me) Number of trigger pulls = W/e setting your aiming for. PSP 15 bps ramp= config mode, flickering yellow, 2 trigger pulls and so on. Rate of fire= Config mode, solid yellow, 1-20 trigger pulls. I set my ROF at 15 (15.2 exactly) soz my hopper can keep up with the ramp. But if you have a better hopper, the ROF can just be set to 26bps