Pm6

[spydertlxmuzzle]

anybody know how to fix a sticking trigger on a pm6?

[Shoot.Kill.Win]

look here (http://www.matrixowner.com)

You need to take the handle off and make sure you have no wires laying beside the trigger and binding it up. You might need to cut the spring down to 2 coils above the rim of the frame.

[Marine Man]

or clean the trigger.

[spydertlxmuzzle]

it's clean, nothing in it. i assume it's the wire problem. i'll check right now.

[Marine Man]

if it isn't the noid wires hitting, and you have taken the trigger out to see if it is clean, then you most likely have a sticky berring. did you oil it? if so then take off all of the excess and then some

[spydertlxmuzzle]

if it isn't the noid wires hitting, and you have taken the trigger out to see if it is clean, then you most likely have a sticky berring. did you oil it? if so then take off all of the excess and then some
[/b]
nah, it was the eye wire. i put it in wrong. i'll make sure not to do that again. it's fine now. thanks to whoever mentioned it, if it was even this forum, it might've been matrixowner.

[Shoot.Kill.Win]

nope came streight from my thoughts

[wsLONGBEACHhomie]

I had the same problem. I tried to fix but I guess the spring flew off. Where can I get a spring at? at a local shop?

[Marine Man]

it should be a standard size but why have the spring? triggers feal much better and faster without springs